English
Français
-
Logo! PLC – Training module
ESD007000
Logo! Siemens® PLC,Basic model:
- 20 I/O (12 Inputs, 8 Outputs), 24 VDC On/Off)
- Pedagogical product : The PLC is on a board with Ø 4-mm safety sockets and can be put on a table ; 24 Vdc, 2.9 A Power supply.
- Supplied with a flash disk including the control software, logic programming
Optional extra:
- CIM communication interface module for LOGO! 8 Modbus RTU interface (RS232/485) 4-port switch; without 4G/LTE/GPS; web configurator
-
S7-1200 PLC – Training module
ESD003000
S7-1200 Siemens® PLC, with Step7 basic 32-bit software
▪ 14 ON/Off 24 Vdc inputs, 10 outputs with display.
▪ 1 0/10 V analog input, 1 +/- 10V 12-bit output.
▪ 1 simulator with 8 miniswitchs.
▪ 1 miniswitch with 4 PROFInet ports (LAN) with a cable. -
M221 PLC Training module
ESD008000
Pedagocial PLC, Schneider M221
14 On/Off Inputs / 10 On/Off Outputs
2 analogue Inputs -
M340 PLC – Training module
ESD002000
M340 Schneider® PLC with a control unit:
▪ 31 inputs, 21 outputs.
▪ 1 I/O analog simulation board.
▪ CAN OPEN link. -
Modular trainer for PLC and HMI (ref ESD100400)
ESD 100 SI / ESD100 SE is a modular board designed to ensure a very progressive training in the field of automation.
Two versions for this bench:
• Siemens® PLC and HMI
• Schneider Electric® PLC and HMI -
Table for technical laboratories, ref EMO100000
Suitable for all your “low voltage” electrical engineering and telecommunications laboratories
Suitable for your laboratories in 300-W Power Electronics and Motors studies equipped with our EM(S)300B power supplies (providing adjustable 3-phase and DC from a 220 V/16A socket) -
Siemens PLC cube
EST100000
Compact et modular , this cube allows to implement a complete chain of automatic control. The cube consists of an HMI and a Programmable Logic Controller. There are also a side for the power supply and a free side allowing to add a new module (a drive for the control of motor for example (cf Cube-Elec 300 in our Power electronics chapter).
